Can You Put Nails In A Fiberglass Oanel Wall

LIQUID NAILS wall adhesive

Key Features

Excellent gap filling
Trowel grade adhesive
Guaranteed not to burn through panels

Recommended For:

adhering FRP panels to cured concrete, cement backerboard, drywall, woods and greenboard.

NOT Recommended For:

adhering FRP panels to wallpaper, exterior surfaces and foamboard (polystyrene). Not recommended for adhering NRP Panels, such as Plas-Tex® by Parkland Plastics.

Available Sizes

3.5 Gal. tin can
1 Gal. can

Coverage

3.5 Gal. can covers 175 sq. ft.
On shine surfaces: 1 Gal. can covers 50 sq. ft.

Specifications

ASTM C-557

Surface Preparation

For all-time results, wall adhesive and substrates should be betwixt l° and 90°F. Surfaces must be structurally sound and dry, free of grease, clay, grit, wallpaper, pigment or anything that would interfere with a bond. Level whatsoever high spots, and fill all cracks and holes with appropriate fillers.

Application Prep

one. Cut and pre-fit FRP panels. 2. Spread wall adhesive with the recommended trowel over the entire back of the FRP panel. 3. As soon as wall adhesive is spread over entire console and before wall adhesive skins over (within 45 minutes), set panel in position and press against wall. 4. Press console firmly into identify, working from the center to the edges until total contact has been made. 5. Bracing may be required if walls or panels are not completely straight. half-dozen. For channel moldings, permanent fasteners and panel spacings, follow FRP panel manufacturer's specifications. For application over concrete: Concrete surfaces need to be dry and completely cured before using this wall agglutinative. When installing FRP panels over below-form physical where wet can penetrate, you lot must start adhere furring strips to the concrete block and then attach a solid surface, such as wood or drywall, to these furring strips, then go on with standard FRP wall adhesive application.